Testel Systems has manufactured, drilled, wired and performed QC procedures on more than 10,000 test fixtures for the ATE industry during the last 18 years.  With 18 years of fixture built experiences and various feedbacks from our valuable customer toward our processes and quality of our fixture. Testel had taken those messages seriously and continuously improve and modify on existing processes to meet the customers' requirement. We also had replaced some of the traditional manual process into computerize process to shorten the generation of fabrication documentation.

Beside the computerize processes, Testel also invested on the Stress Simulation tools and strain gauge measurement equipment, which cost us of a lot of money. With these equipments, we are able to analyze the stress level in the board before building the fixture. It also able to do the strain measurement on each corner of the BGA chip to ensure the stress acting on the chip is within the customer specification.

In year 2000, Testel had taken the initial move to setup an ICT development team by employing two programmers and invested a GR 2283 machine. And we expand our ICT development team gradually from two programmers to the present five programmers. Beside the headcount increase, we also had invested a few hundred thousand of US dollar in upgrading my GR2283 into a Gr2284 system and buying two Agilent 3070 systems, with the configuration of two modules and four modules.